Placer consists of a set of three bars fabricated from heavy aluminum channel, assuring you of years of trouble-free service.
Each bar has two 10" rubber rollers to allow any size casket to roll smoothly and without drag.
One bar comes with a Brake Attachment to lock the casket into the desired position during the ceremony.
The E-Z Casket Roller Bars will fit on any device up to 39" between rails.
Weight 51 lbs.
Please allow 6-8 weeks.

1. To set up — On any lowering device set at any width, lay the 3 Casket Roller Bars on the side rails. The brake bar should be in front. The 3 bars can be placed anywhere on the device, wherever they best suit your type of service.2. To use — The casket is placed on the front rollers, with the brake off, and then pushed along until it rests in the proper position on all three bars. Tighten the brake.3. To remove — At the conclusion of the service, tighten the straps of the device and while one end of the casket is raised up, remove two bars. Repeat procedure at other end removing last bar. Casket is then ready to be lowered.